Blades for Graphtec Plotters
Plotter Blades
Images shown are for identification only - they are not to scale.
Most customers now use Smart Knives but for those who particularly want them and for resellers we still make the "ordinary" blades shown below.
If you are unsure about which type/s you need you are welcome to call us on 01928 739799 or email: info@edwardmathias.com
G09V
Tool Setting CB09+0
£15.00
+ delivery & VAT
For cutting most common materials up to about 250 microns.
When used in the "standard" (Blue Nose) blade holder supplied with Graphtec machines this replaces the "standard" blade type CB09u
Some older Graphtec holders use blades with a coil spring which we supply when required.
Most customers prefer to use
because it is pre-set and easier to use.
G09F
Tool Setting CB09+0
£16.00
+ delivery & VAT
For cutting some materials up to about 400 microns.
When used in the "standard" (Blue Nose) blade holder supplied with Graphtec machines this can be used for cutting some thicker materials than can be cut with the G09V.
It can sometimes (but not always) be used as an alternative to the G29F.
Some older Graphtec holders use blades with a coil spring which we supply when required.
Most customers prefer to use
because it is pre-set and easier to use.
G29F
Tool Setting CB15+0
£25.00
+ delivery & VAT
For cutting thicker materials than can be cut with G09 Blades.
These do not fit the "standard" (Blue nose) blade holder normally supplied with new machines
To use these these you need a Graphtec Blade Holder Type PHP33-CB15N-HS
(Red Nose - and expensive)
Most customers prefer to use
because it is pre-set and easier to use.
G29R
Tool Setting CB15+0
£25.00
+ delivery & VAT
For cutting thicker materials than can be cut with G29F Blades.
These do not fit the "standard" (Blue nose) blade holder normally supplied with new machines
To use these these you need a Graphtec Blade Holder Type PHP33-CB15N-HS
(Red Nose - and expensive)
We advise you also read:-
We also make "specials" for cutting unusual materials.
To show them here is more likely to be confusing than constructive.
If you need to solve a cutting problem you are welcome to call us.
We can usually help.